K HERO pro max 2
PRODUCT MANUAL

ATTENTION: During First Use: remove the slip between batteries.

1. How To Use The Pro Max 2 Portable Karaoke Microphone

1.1 You can turn on Pro Max 2 by sliding the Power Switch to On.

1.2 To connect your phone/tablet or any other Bluetooth device to Pro Max 2, please enable the Bluetooth option on the device and select 'Microphone Speaker 20W'. You will hear a beep sound from the Pro Max 2 once connected. And also the BT letter on the screen should stop flashing.

1.4 Select a song from your favourite music app and it will be played from Pro Max 2's built-in speaker.

1.3 You can adjust the volume of the music from your Bluetooth device or the sliders on Pro Max 2.

1.4 If you leave Pro Max 2 connected to your phone after turning it off, it will attempt to re-connect to your Bluetooth device after it's turned on again.

1.5 To connect Pro Max 2 to your car speakers. press the 87.5/108 buttons , then tune your car radio channel to the matching FM channel.

1.6 press “High” button to switch between High/Low Pitch mode.

1.7 Press “Music Icon” button ONCE for for original vocal cancellation, do not HOLD the button, if the button has been held and you hear the “beep” sound, the voice cancellation function is turned off and you will need to restart your Pro Max 2 to activate it again. the effectiveness of vocal cancellation depends greatly on the song type.

1.8 For connection to your home theatre system/ external speaker, You will need a 3.5mm AUX audio cord (Male to Male). they are readily available on eBay and other retail stores.

1.9 Pro Max 2 supports up to 16GB of Micro SD cards. It can be used to record voice clips. once the SD Card is inserted use the red REC button on the microphone to start/end recording. the rec/play button can be used to playback the recordings. Note: The SD recording is a bonus function and is only for experimental use. It is not for professional use.

2. How To Pair Two Pro Max 2 To The Same Bluetooth Device

2.1 Turn on the first Pro Max 2, connect it to your bluetooth device.

2,2 Turn on the second Pro Max 2

2.3 Hold the “Music Icon” Button (Bottom Right) for 10 seconds (3 seconds for subsequent attempts) on the first Pro Max 2.

2.4 Once the BT letters stops flashing on the second Pro Max 2 screen and you hear a “beep” sound, The pairing is successfully completed.

3. Charging/Battery Life

3.1 To charge Pro Max 2, please use the provided USB cable and plug into any USB charging port/adapter.

3.2 Charging Pro Max 2 to full battery should take a few hours.

3.3 On a full charge the Pro can be used for approximately 5-8 hours with moderate use.

4. Troubleshooting

  • You can not discover/connect to Pro Max 2 with your Bluetooth device.

Potential Cause: The Pro Max 2 is still connected to the previous Bluetooth device.
Solution: Please disconnect the Pro from your Bluetooth device if you wish to have it connected to another Bluetooth device instead.